RECOMMENDED TOOLS FOR ASSEMBLY
n
7/16” wrenches (2)
n
Tape Measure
n
Bolts, nuts, washers*
n
Needle nose pliars
n
Drill & drill bit**
n
Safety glasses
n
Hammer or mallet
n
Phillips screwdriver
*size & quantity deter-
mined by model of saw
**bit size slightly larger
than bolt
UNASSEMBLED UNIT
1 - SS3800 Stop System
(optional)
2a - top shelf
b - bottom shelf
3a - left side
b - right side
4 - 3” locking casters
5 - 10’ tape measure
6 - hardware
(16 nuts & 16 bolts)
NOTE: WHEN STAND IS FULLY ASSEMBLED SLOTS ON
WINGS ARE TO THE REAR.
STEP 1) Fasten side
frames to bottom shelf
using bolts & nuts
provided. Finger
tighten.
STEP 2) Measure base
height of saw.
STEP 3) Using tape
measure & straight edge,
set top shelf below wings
equal to base ht. of saw.
Insert bolts & finger
tighten nuts.
1
3a
2a
6
3b
2b
4
5
