WARNING
GENERAL INFORMATION You have purchased a ROUSSEAU MITERSAW SUPER
STAND SS2875. This unit is especially useful to the finish carpenter, cabinet or furniture
builder. This stand supports stock while you cut. With optional stops system, it features stops
up to 84”, is collapsible, easy to store, is mobile with locking casters, has instant set up time
and is portable. It fits most 10” - 15” saws up to 27 1/4” wide.
WARRANTY This product has a lifetime warranty to the original purchaser. The warranty
applies to defects in materials and workmanship only. We will repair or replace the product or
part(s) at our discretion. This warranty does not apply to product failure or defects due to
direct or indirect misuse, abuse, negligence, accidents, alterations, repairs or lack of mainte-
nance. The item must be shipped prepaid to our Clarkston, WA location and will be returned
by standard shipment via carrier of our choice.
SAFETY GUIDELINES Pay special attention to the following section headed by this symbol:
They contain important safety information concerning a hazard that may
cause serious injury or death, and/or damage to mitersaw and/or stand if
equipment is not used properly. Please read the following instructions carefully.
Always operate on flat level surface with casters locked. Failure to do so
could result in tipping or rolling table which could cause kickback and/or
loss of fingers.
Be sure saw is bolted in securely. Failure to do so could result in injury to
self or saw.
Make sure top of saw base is level with arms. Failure to do so could
result in kickback, causing injury to self and/or saw.
When using adjustable stops, always hold work tight to table at a safe
distance from blade, until saw has come to a complete stop. Failure to do
so could result in kickback, causing injury to self, saw, or work piece.
When cutting small pieces use a hold down stick to hold work in place
until saw has stopped. Failure to do so could result in kickback, causing
injury to self, saw, or work piece.
Allow saw to stop at bottom of travel before raising. Failure to do so
could result in kickback, causing injury to self, saw, or work piece.
Keep fingers clear of hinge mechanisms when dropping table arms.
Failure to so so could result in pinching or loss of fingers.
HOLD WING WITH
ONE HAND...
...WHEN
RELEASING
CATCH.
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
