20
P/N 1011139 Rev. G 11/15
1
With power off and toaster cool, remove top covers. Remove
current belts by either removing lacing pin or using scissors
or razor knife, carefully cut the belt free of the wire, drive belt.
Installing the HCT Clip Style Belt
3
With tension spring in run position install belts by hooking
back of each clip to wire belt and gently pulling end of belt
toward you while applying downward force to clip the front part
of the clip to the next metal wire.
2
Thread the clipped end of the belts under rear cover bar.
Position belts in the top middle of unit with clipped end
facing front and the length of belts draped over the rear of the
toaster.
4
Turn on toaster and let belts feed 1 revolution until the
belts are in the top center position again. Depress wire belt
tension springs in and down until they lock. Position both end of
belts together and line up so lacing is even. Insert the pin to join
both sides of belt together. Assure the clips are attached to the
wire belt.
5
Verify belt alignment is even from side to side of each belt.
Depress tension springs in and up to release from lock
position to run position. Verify belt alignment. Re-verify the
clips are attached to the wire belt. Replace top covers and start
toaster.
P/N 1011207 11/12
HCT-2010 CLIP STYLE BELT INSTRUCTIONS
Summary of Contents for HCT-2010
Page 21: ...21 P N 1011139 Rev G 11 15 NOTES...
Page 22: ...22 P N 1011139 Rev G 11 15 NOTES...
