Section 10 Safety Data Sheets
SG7MTS Manual
www.rottlermfg.com
10-9
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
829364 - Alco Super-Lube Multi-Purpose EP-0 Grease
Page 2/6
Issue Date:
02-May-2017
Status:
FINAL
Inhalation:
First aid is not normally required. If breathing difficulties develop, move victim away from source of exposure and into
fresh air in a position comfortable for breathing. Seek immediate medical attention.
Ingestion:
First aid is not normally required; however, if swallowed and symptoms develop, seek medical attention.
Most important symptoms and effects, both acute and delayed:
Inhalation of oil mists or vapors generated at elevated
temperatures may cause respiratory irritation. Accidental ingestion can result in minor irritation of the digestive tract, nausea and
diarrhea. Prolonged or repeated contact may dry skin and cause irritation
Notes to Physician:
When using high-pressure equipment, injection of product under the skin can occur. In this case, the
casualty should be sent immediately to the hospital. Do not wait for symptoms to develop. High-pressure hydrocarbon injection
injuries may produce substantial necrosis of underlying tissue despite an innocuous appearing external wound. These injuries
often require extensive emergency surgical debridement and all injuries should be evaluated by a specialist in order to assess the
extent of injury. Early surgical treatment within the first few hours may significantly reduce the ultimate extent of injury.
SECTION 5: Firefighting measures
NFPA 704 Hazard Class
Extinguishing Media:
Dry chemical, carbon dioxide, foam, or water spray is recommended. Water or foam may cause frothing of
materials heated above 212°F
/
100°C. Carbon dioxide can displace oxygen. Use caution when applying carbon dioxide in
confined spaces. Simultaneous use of foam and water on the same surface is to be avoided as water destroys the foam.
Specific hazards arising from the chemical
Unusual Fire & Explosion Hazards:
This material may burn, but will not ignite readily. If container is not properly cooled, it
can rupture in the heat of a fire.
Hazardous Combustion Products:
Combustion may yield smoke, carbon monoxide, and other products of incomplete
combustion. Oxides of sulfur, nitrogen or phosphorus may also be formed.
Special protective actions for fire-fighters:
For fires beyond the initial stage, emergency responders in the immediate hazard
area should wear protective clothing. When the potential chemical hazard is unknown, in enclosed or confined spaces, a self
contained breathing apparatus should be worn. In addition, wear other appropriate protective equipment as conditions warrant
(see Section 8). Isolate the hazard area and deny entry to unnecessary and unprotected personnel. Stop spill
/
release if it can be
done safely. Move undamaged containers from immediate hazard area if it can be done safely. Water spray may be useful in
minimizing or dispersing vapors and to protect personnel. Cool equipment exposed to fire with water, if it can be done safely. Avoid
spreading burning liquid with water used for cooling purposes.
See Section 9 for Flammable Properties including Flash Point and Flammable (Explosive) Limits
SECTION 6: Accidental release measures
Personal precautions, protective equipment and emergency procedures:
This material may burn, but will not ignite readily.
Keep all sources of ignition away from spill
/
release. Stay upwind and away from spill
/
release. Avoid direct contact with material. For
large spillages, notify persons down wind of the spill
/
release, isolate immediate hazard area and keep unauthorized personnel out.
Wear appropriate protective equipment, including respiratory protection, as conditions warrant (see Section 8). See Sections 2 and
7 for additional information on hazards and precautionary measures.
Environmental Precautions:
Stop and contain spill
/
release if it can be done safely. Prevent spilled material from entering sewers,
storm drains, other unauthorized drainage systems, and natural waterways. Use water sparingly to minimize environmental
contamination and reduce disposal requirements. If spill occurs on water notify appropriate authorities and advise shipping of any
hazard. Spills into or upon navigable waters, the contiguous zone, or adjoining shorelines that cause a sheen or discoloration on
the surface of the water, may require notification of the National Response Center (phone number 800-424-8802).
Health:
0
Flammability:
1
Instability:
0
0 (Minimal)
1 (Slight)
2 (Moderate)
3 (Serious)
4 (Severe)
Summary of Contents for SG7MTS
