Rottler SG10XY, Operation And Maintenance Manual

Page: 46 / 146

Section 4 Control Definitions SG10XY Manual
www.rottlermfg.com
4-6
LAMP
Turns work light on and off
Center pilot
Locks and unlocks spindle sphere
WORKHEAD FLOAT
Floats workhead when pushed RED and clamps when pushed BLUE
START SPINDLE
Turns spindle on and off.
SAFE STOP
Immediately stops downward feed and goes to finish options mode
HANDWHEEL: 0.0100 / 0.0010
Press these and you can move the spindle up and down with the handwheel. 0.0100 moves .010 per
click of the handwheel. 0.0010 moves the spindle .001 per click. Press and hold and you can change
movement.
SPINDLE ZERO
Indexes spindle in the position you want after auto cycle. Manually rotate into desired position and press
“Spindle Zero” after auto cycle spindle will return to this position.
V ERTICAL ZERO
Resets DRO to zero. Reference point all heights are set at. More on this later.
ADDITIONAL DEPTHS
Additional amount of material removed after auto cycle. If a seat does not clean up you can use these
buttons to remove more material without changing finish cutting depth. Must be below “lower cutter
head over pilot. “and workhead float after auto cycle must be unchecked. These can be reprogramed by
pushing and holding the button and entering in a different figure.
Index spindle. Press this and spindle indexes to position set with “Spindle Zero” button
Workhead float after auto cycle:
If its checked it floats, if not it doesn’t, after auto cycle.
FEED RATE
Press and hold to set Feed rate
SPINDLE RPM
Press and hold to set spindle RPM
SET
Push and hold to set height. Whatever height the spindle is at will automatically be programed when
pushed and held. This height is in reference to the preset vertical zero. More on this later.
MOVE
Push this and spindle will move to the position programed buy the SET button.
ANGLE
Abs
- Actual angle the angle sensor is at.
Zero
– press to “0” angle sensor. Abs will not change.
ALL OF THESE PREVIOUS BUTTONS WORK THE SAME IN ALL MODES