Rottler SG10XY, Operation And Maintenance Manual

Page: 57 / 146

Section 5 Operating Instructions SG10XY Manual
www.rottlermfg.com
5-3
Overhead Cam C Clamp System
Using 10mm Allen wrench, remove the existing lower fixed plate on the 360 degree fixture (left and right)
Install the C Clamp, you must use the two bolts included with the fixture and make sure is good and tight
The cylinder head gasket surface must be against the machined surface of the U Clamp Fixture; Slide the
stopper rod equally and push the cylinder heads against the stopper rods.
Note: for some cylinder heads, you make need a spacer against between the cylinder head and
the stopper rod (not included)