Page 22
T
ROUBLESHOOTING
XI. CONTROL SWITCH TESTING PROCEDURE
Utilize the following continuity charts to test your control switch if you suspect that it is not
functioning properly. You need to unplug the 8-pin connector from the
C
RUISE
M
ODULE
to perform
these tests.
1.
Ground the test light lead and verify that the light works by probing a known power source.
2.
Follow the test charts below using the appropriate chart for your control switch.
Your control switch is a
Closed Circuit Control Switch
if:
1.
Its
ROSTRA
part number is
250-3002, 250-3018, 250-3020, 250-3021, 250-3026,
250-3032, 250-3084, 250-3091, 250- 3100, 250-3120, 250-3125, 250-3126, 250-3127,
250-3133, 250-3167, 250-3168, 250-3169, 250-3175, 250-3180, 250-3194, 250-3304,
250-3328, 250-3421, 250-3446
OR
2.
You must push the control button to the
left
for the
RESUME/ACCEL
function.
Your control switch is an
Open Circuit Control Switch
if:
1.
Its
ROSTRA
part number is
250-3357, 250-3358, 250-3443, 250-3444, 250-3592,
250-3593, 250-3632, 250-3633, 250-3594, 250-3595, 250-3742, 250-3743.
OR
2.
You must push the control button to the
right
for the
RESUME/ACCEL
function.
OR
3.
It has a
Green
LED Indicator Light.
OR
4.
It is a
ROSTRA Radio Frequency
(RF)
control switch.
The
CRANK
or
START IGNITION SWITCH POSITION
refers to the momentary state when the key
starts the engine just before it returns to the
RUN IGNITION SWITCH POSITION.
ON
ON
ON
ON
ON
