How to Use the Reader
AY-Q6x60 Series Installation and Programming Manual
17
4.2
Manual LED and Buzzer Control
LED and buzzer behavior depend upon the reader firmware. For
example, three beeps on reset and successful configuration, or one
short beep and a flashing LED upon card transmission. However, it
is possible that the host control panel, to which the reader is
connected, may control the LED, the buzzer, or both. This depends
upon manipulation of the LED/buzzer control input, and only if
these options are enabled by the reader configurations.
These settings can be overridden using the brown LED/buzzer
control wire:
LED/buzzer control wire is left open:
LED and buzzer behave naturally, on the basis of firmware
preferences.
LED/buzzer control wire is connected to ground:
If the LED control is enabled, the LED turns green.
If the buzzer control is enabled, the buzzer continuously
buzzes.
If both LED and buzzer control are enabled, the led turns
green and buzzer contentiously operated.
Use the LED/buzzer control wire to drive the behavior of the LED
and buzzer directly from the access control software.
LED and buzzer control function can be only programmed by
configuration card. They cannot be programmed using the
reader keypad.