Page 8
07/04
AC-F43
Installation
Mounting the AC-F43 Controller
1)
Before starting, select the location to mount the AC-F43
controller.
2)
For wall mounting use the mounting template as a guide to drill
the mounting and cable holes in the wall. For US Gang Box
installation there are two holes on the back cover aligned for the
US Gang Box. (Shown marked as "A" in diagram below).
3)
Screw the AC-F43 back cover to its mounting location.
4)
Wire the controller according the wiring instructions of the
following page.
5)
Mount the AC-F43 to the back cover.
6)
Secure the AC-F43 by using the supplied security screw in the
Installation Kit. An L-Shaped tool is provided for use when
tightening the security screw.
Page 9
07/04
Wiring the AC-F43
The controller is supplied with a 22" (60cm) pigtail, having a 10
conductor cable. To wire the Controller, perform the following
steps.
1)
Prepare the controller cable to the required length.
2)
Splice the controller pigtail wires to the corresponding devices
and cover each connection. Refer to the wire color guide
provided below and to the wiring diagrams provided on the
following pages.
Wire Color Guide
3)
Trim and cover all conductors that are not used.
A few of the typical wiring diagrams are shown on the next three
pages; for other wiring diagram examples refer to the support
section of the Rosslare Web Site.
http://www.rosslaresecurity.com
AC-F43
RED
BLACK
GREEN
WHITE
BROWN
BLUE
YELLOW
ORANGE
PURPLE
GRAY
V INPUT
GROUND
REX / BL
IN / MONITOR
N.C.
LOCK: COM
N.O.
AUX: COM
N.O.
N.C.
COLOR
DESCRIPTION
Tamper
Lens
A
A
