Ross TC700M, Operator'S Manual, Page: 5 / 44

DAILY CLEANING PROCEDURE
NOTE:
USE ONLY NEUTRAL pH DETERGENTS AND SANITIZERS .
1) Remove Blade Assemblies from machine.
2) Inspect Blade Assemblies and remove any bent blades.
3) Clean Blade Assemblies with a mild neutral pH detergent
solution. Blade Assemblies may be immersed in this solution
for up to ten (10) minutes.
4) With Blade Assemblies removed, clean entire machine with a
mild neutral pH detergent and a stiff brush. SPECIAL
ATTENTION SHOULD BE GIVEN TO THE UNDERSIDE OF
THE LOWER GUIDE FRAME.
5) Flush Blade Assemblies and machine with clean hot water or
steam. All traces of detergent must be removed.
6) Sanitize entire machine using only neutral pH sanitizers.
7) Rinse machine and Blade Assemblies with clean hot water.
8) Liberally spray the Magnetic Head Plates, Blades, Guide
Uprights, Main Uprights and Seals with ROSS 601 Oil.
9) Replace Blade Assemblies in machine.
CAUTION:
NEVER USE CAUSTIC CLEANING SOLUTIONS ON THE ROSS
TENDERIZER. DAMAGE TO MAGNETIC HEAD PLATES AND
SEALS WILL RESULT.
NEVER LET MAGNETIC HEAD ASSEMBLIES SOAK IN
CLEANING SOLUTION LONGER THAN TEN (10) MINUTES.
MN700-MC0010
iii
For more detailed instructions on Cleaning and Lubrication, refer to the Operating Procedures
Section of the Instruction manual.