Ross TC700M, Operator'S Manual, Page: 29 / 44

7 The machine’s belt can be manually moved without the blade assemblies in place to allow for the
cleaning of the belt with a spray of soap and water. Inspect conveyor belt for damaged sections and
replace as required.
8. Reinstall the blade assemblies by sliding the head plate into position on the head frame making sure
that the rib on the magnetic head carrier is positioned in the corresponding slot on the head frame.
9. Install the upper outer guide bar (‘top’ marked on bar – slot goes down)
10. Then slide the lower blade guide into position on the guide frame and install the lower outer guide
bar. To accomplish this sometimes it is necessary to slightly lift the lower blade guide USE CAUTION
NOT TO PUSH HANDS INTO THE BLADES AT THE BOTTOM OF THE LOWER BLADE GUIDES.
11. Check that the installed head assembly moves freely in its installed position. It should slide within the
slots on the guide bar and head/guide frames.
12. Reinstall the Reset Plate and fasten with the original acorn nuts and washers. Tighten to a torque of
50 ft lbs.
13.
After every cleaning, spray the blade assemblies, tops of the blades, main uprights and guide
uprights with ROSS 601 white mineral oil (or equivalent).
MN700-MC0010
6-3