Ross Master Control MC1-PANEL-16, User Manual, Page: 22 / 58

22 • Physical Installation MC1-PANEL-16 User Guide (v4.0)
2. If the Redundant Power Supply option is available, plug the second 12VDC cable into the connector marked
PS2
.
3. Connect the supplied AC power cable into the power module and into the AC outlet.
Control Panel Button Inserts
Insert films can be installed into most buttons on the MC1-PANEL-16. Insert films allow you to label specific
source buttons, control buttons, or replace the default button names with those of a different language. Button insert
template can be downloaded from Ross Video.
To install a button insert
1. Remove the Cap Assembly from the Switch Assembly by grasping it firmly and pulling away from the control
panel surface.
2. Remove the Lens from the Diffuser using a common end micro screwdriver.
3. Place the Insert Film into the Lens so the readable side is facing up. The notches on the sides of the Lens must
be at the sides of the text on the Insert Film.
4. Aligning the notices on the sides of the Lens and Diffuser, press the Lens and Diffuser together until they click.
5. Aligning the notches on the side of the Cap Assembly to the tabs on the side of the Switch Assembly, press the
Cap Assembly down onto the Switch Assembly with a rolling motion until they click together.
Cap Assembly
Switch Assembly
Diffuser
Lens
FTB
Diffuser
Insert Film
Lens
Cap Assembly
Switch Assembly