3–2 • User Controls
DAC-8418-A User Manual (Iss. 01)
Card Overview
This section provides a general overview of the DAC-8418-A components. For information on
the LEDs available on the card-edge, refer to the section “
Control and Monitoring Features
” on
page 3-6.
Figure 3.1 DAC-8418-A — Components
SW1 — Remote Control
Use
SW1
to disable remote control of the DAC-8418-A from DashBoard.
Set
SW1
as follows:
•
ON
— Select this setting to disable remote control from DashBoard. The parameters and
settings cannot be changed via DashBoard and must be changed using the card-edge
controls. You can still monitor the status of the card using DashBoard.
•
OFF
— Select this setting to control the DAC-8418-A exclusively from DashBoard. The
card-edge controls are ignored.
SW2 — DIP Switch Control
Use
SW2
to determine whether DIP Switch settings are applied or ignored.
Set
SW2
as follows:
•
ON
— DIP Switch status is reported in DashBoard, and DIP Switch settings are applied.
Any parameter adjustments made in DashBoard are ignored.
•
OFF
— DIP Switch status is reported in DashBoard, however DIP Switch settings are
ignored. Parameter adjustments made in DashBoard are applied.
SW3
SW3
is used for factory service only. Do not use
SW3
unless instructed to do so by Ross
Technical Support personnel.
SW4
SW4
is used for factory service only. Do not use
SW4
unless instructed to do so by Ross
Technical Support personnel.
SW5, SW6 — Output Mode Selection 1
SW5
and
SW6
are used in conjunction to set the output mode of the first audio converter. Refer
to the section “
Setting the Output Modes
” on page 3-4 for details.