Ross ASI-310, User Manual

Page: 15 / 34

ASI-310 User Guide (v5.0) Hardware Overview • 15
Supported Rear Modules
This section provides cabling diagrams for the rear modules. The type of rear module depends on the frame the card
is installed in.
MDL-R10 Rear Module
This rear module is required when installing the ASI-310 in the DFR-8310 series frames. Each MDL-R10 Full
Rear Module accommodates one card and uses two slots. Each MDL-R10 provides a SMPTE 310M input, an ASI
input, a SMPTE 310M monitoring output, one SMPTE 310M output, and an ASI output. ( Figure 1.3 )

The ASI-310 is not compatible with the DFR-8310-BNC frames.
Figure 1.3 Cabling for the MDL-R10 Rear Module
Unknown
Rear Module
(DS7) Green When lit green, this LED indicates the rear module is supported by
the card.
Red When lit red, this LED indicates that the rear module connected to
the ASI-310 is not suitable for use with the ASI-310. Operation will
not be correct.
Video Error
(DS8) Green When lit green, this LED indicates the video is supported by the card.
Red When lit red, this LED indicates that the signal connected to the
video input is a known type, but is not ASI; for example, it could be
SDI or HD-SDI. Operation will not be correct.
DS9 This LED is redundant with DS2.
ASI IN (DS10) This LED is redundant with DS5.
310 IN (DS11) Green When lit green, this LED indicates that there is a valid 310 input.
Red When lit red, this LED indicates that there is no 310 input.
ASI
OVERFLOW
(DS12) Green When lit green, this LED indicates that the ASI input throughput is
suitable for conversion 310.
Red When lit red, this LED indicates insufficient 310 bandwidth to carry
contents of ASI signal.
Table 1.1 LEDs on the ASI-310
LED Color Display and Description
5 6
310 In
ASI In ASI Out
3
310 Out
GPIOs
1
310 MON
Out
2
4
N/C