10
screen) will blink, while blinking press the On/+ (increase) or Off/- (decrease) button to adjust
stimulation intensity for Channel 2.
If using only one channel, you can simply leave Channel 2 at zero.
•
Press CH again to lock in treatment intensity.
Note:
You will feel intensity increase or decrease as you select the intensity level. You can use this
as a guide to select a level that is most comfortable for you.
•
Treatment will proceed and continue until either the timer runs down, or if in C (continuous time
mode) until you manually power the device off.
Turning OFF the TOP TENS™
•
You can terminate treatment at any time by:
-
Pressing the Mode button to reset the channels to “0” – this will not power off the device
but allow you to change treatment options, or
-
By pressing and holding the Off/- button (approximately 10 seconds) until the screen shuts
down – this will completely power off the device.
-
If any part of the device has a setting that is blinking on the screen, you need to lock in the
setting by pressing either the Mode or CH buttons before the device will allow you to power
off.
Special Notes:
•
The TOP TENS device allows you approximately 30 seconds to make selections while the Channel
Intensity is blinking and while the Treatment Time is blinking. If no selection is made, the treatment will
operate under the default selection of channel 1 and 30 seconds.
•
If you fail to press the Mode button to lock in a selection for the Channel Intensity and the Treatment
Time after making your desired selection, the device will lock it in automatically after approximately 30
seconds.
•
If you change the Therapy Selection (P1-P8) at any time during the therapy session, the intensity
level will reset to “0” as shown on the screen, for your safety.
•
The TOP TENS device is programmed to shut off automatically during the following situations:
1. Program timer reaches zero, or
2. If no treatment program has been set after approximately 60 seconds.
