RevoPRO Operations Manual
p. 9
luminaire in order to project without obstructions to the gobo design.
3. The RevoPRO™ is equipped with a unique safety feature, the Friction
Lock. Depress the metal slider located on the left side of the RevoPRO™
to extend a knurled brake cylinder.
This brake presses against the inside wall of the iris slot, securely hold-
ing the RevoPRO™ in place.
Note: To install the RevoPRO™ into your luminaire it is necessary that
the Friction Lock Slider be in the UP position, with the lock disengaged.
4. Attach a safety cable to the RevoPRO™ and then to the yoke of your
luminaire or other secure point.
The D-cut out in the metal housing to the right of the motor box will
accept the spring clip of a standard safety cable or the loop end of a
small safety cable.
Power and Data
The RevoPRO™ uses an internal, auto-sensing, auto-switching power supply
suitable for almost any location.
1. Connect it to any suitable 100-240VAC 50/60hz power source using an
ANSI standard IEC cable.
2. If using a DMX controller, connect a 5-pin DMX cable from your light-
ing desk/console or from the pass–thru of another DMX device into the
DMX input port on your PSU.
6. CHOOSING OPERATION MODE AND SETTING DMX ADDRESS
When powered on, the RevoPRO™ will restore to its previous configuration. If
this configuration was an indexing mode (3-7) then the unit will go through a
