p. 18
5 = Slide 116° with speed (slow to fast)
6 = Clock ticking
7 = Shaking and rotate
8 = Slide 360° with speed (slow to fast)
9 = March 5°, 5°, 5°, 5°, stop and continuous
Once applied to a specific gobo wheel, you can further set speed and direc-
tion of each of these sequences.
Press B1 once to enter SETUP . Display will momentarily change to
1.
SET- and then return to the previous display, blinking.
Press B1 until E.6XX appears in the display.
2.
Each X corresponds to the effect applied to gobo wheel A and B
respectively. For example E.600 indicates that Effect 0 (continuous
rotation) has been applied to Gobo A and Gobo B. E.637 indicates
that Effect 3 (swing 21°) has been applied to Gobo A and Effect 7
(Shaking and Rotate) has been applied to Gobo B.
Press B3 to increment the Effect Number for Gobo A
3.
Press B4 to increment the Effect Number for Gobo B
4.
Press B2 once. Display will show A._XX for speed and direction of
5.
GOBO A
Press B4 to increase speed. Positive numbers indicate CW rotation.
6.
Press B3 to decrease speed. Negative numbers indicate CCW rota-
7.
tion.
Press B2 again to switch to Gobo B. Display will show B._XX
8.
Press B4 to increase speed. Positive numbers indicate CW rotation.
9.
Press B3 to decrease speed. Negative numbers indicate CCW rota-
10.
tion.
Press and hold B2 to SAVE.
11.
Depending on the effects sequence selected, RevoPRO may run through a
homing sequence before activating the specified effects. To adjust the speed
and direction of this program, repeat steps 1-12 without changing the Effects
numbers in steps 1-4. RevoPRO will recall and restore the last programmed
effects sequence in the event of a power loss or Operation Mode change.
Note: Some effects sequences (notably, #3, #6, #9) that create quick alternating
movements may and which are run at high speeds may cause minor clicking
noises due to the fast direction changes. Reduce the speed settings to minimize
this.
