Channel
Function
Description
1
Command
0-44% (0-113)
= No Action
45-49% (114-126)
= All Home
50-54% (127-138)
= Lamp On
55-59% (139-151)
= Lamp Off
60-100% (152-255)
= No Action
Commands will only activate if level is held for 3
seconds.
2
Dowser
0-100% (0-255)
= Full Closed to Full Open
3
Wheel 1
0% (0)
= Stop
1-100% (1-255)
= 4.5-110RPM (linear)
4
Wheel 2
0% (0)
= Stop
1-100% (1-255)
= 4.5-110RPM (linear)
5
Wheel
Directions
0-25% (0-65)
= Wheel 1 CW, Wheel 2 CW
26-50% (66-128)
= Wheel 1 CCW, Wheel 2 CCW
51-75% (129-192)
= Wheel 1 CW, Wheel 2 CCW
76-100% (193-255)
= Wheel 1 CCW, Wheel 2 CW
6-13
Additional
Accessories
Exact function depends on accessories used.
Note that the lamp brightness function is not controlled by DMX. It is controlled in the
same way as in Manual Mode.
When the unit powers up in DMX mode, the lamp will be off and the shutter will be in
the closed position. If no DMX signal is detected, the system will stay in that state. If a
valid DMX signal is detected and the unit has finished homing, it will be fully
controllable as described above.
Troubleshooting
Power indicator will not light.
Check that unit is plugged in and turned on.
Check that the fuse has not blown.
Power indicator lights, but DMX OK indicator will not light.
Check that unit is properly connected to a DMX controller.
Check cabling.
Check DMX signal with another device.
Check that DMX cable run is properly terminated.
DMX OK indicator flashes erraticly and/or unit behaves erraticly.
Check that DMX cable run is properly terminated.
DMX OK indicator lights, but unit does not respond to commands.
Check that DIP switch #3 is in the OFF position.
Check channel addressing.
Unit seems to respond to DMX, but not with all functionality.
