Chapter 5: Subsystem Maintenance
Replacing a Failed Hard Drive
5-19
Figure 5-17: Opening the Drive Tray Front Flap
Step 4.
Remove the drive tray by pulling it one inch away from the drive
bay. Wait for at least 30 seconds for the disk drive to spin down
(if the disk drive is removed for a different purpose, e.g., cloning
the members of a logical drive or Copy & Replace),
and then
gently and carefully withdraw the drive tray from the chassis. (See
Figure 5-18
)
Figure 5-18: Removing a Drive Tray
Step 5.
Remove the four (4) retention screws
that secure the hard drive
from the sides of the drive tray (two on each side.) (See
Figure 5-
19
)
Figure 5-19: Loosening the Hard Drive Screws
Step 6.
Install the replacement hard drive.
Please refer to the complete
hard drive installation procedures in
Section 2.6.
