Page | 10
TF 200.01.0020_ENG
4.1.2A
Mount support arms on profile
At each motor column, a support arm should
be placed on top of the adjustment screw.
Do note, that the inner support arms must not
be more than 60cm (23.5in) apart. Also note
that the outermost support arms must face
inwards with their outer bracket. This is done
by unscrewing the bracket.
4.1.2B
Mount the bracket with flatnut on the
profile in each end
Tighten the bottom screws to fasten the
bracket.
4.1.2C
Mount the adjustment screws on the leg,
in line with where the support arm will be
placed.
4.1.2D
Mount the profile on the motor columns
