Roper Whitney STR 750, Operation, Parts & Maintenance Manual

Page: 19 / 53

19
STR 750 ASSEMBLY INSTRUCTIONS
The STR 750 machine is delivered flat packed and the following instructions in conjunction with
the exploded view opposite should be followed.
After removing the various parts from the packaging, identify them against the parts shown in the
figure opposite. (Report any shortages immediately).
1. Attach item 4 to item 2 with the fixing hardware provided.
(This immediately adds stability to the machines base channel).
2. Attach item 3 to item 2 with the fixing hardware provided.
3. Screw item 3 onto the stud attached under item 1.
4. Lift and place item 1 onto item 3 ensuring that the fixing holes on each side and underneath
line up with each other. Secure both these items together with the fixing hardware
provided.
5. Attach item 5 to item 2 by carefully tipping the machine upwards at the folder blade hinge
end to gain access to the fixing hole in the machines base channel. Secure with the fixing
hardware provided, screwing it into the tapped hole in the bottom of the item.
6. Connect the pneumatic cylinder air lines to the appropriate connections on item 6.
NOTE! Connect the cylinder top hose to port 4 on the foot pedal and the bottom hose to
port 2.
Fully assembled STR 750 Duct Forming
Machine from flat packed.