Ronson RFP200, Instruction Book

Page: 12 / 32

11
notE:
Never push down any
foods with your hands and
do not put your hands down
the food chute at any time
during processing.
For using the processing blade
– with
the ingredients inside the processor
bowl, start the unit on low speed
(1) moving to higher speeds (2 or 3)
if necessary. Before commencing
ensure that the ‘food pusher’ is in
place to avoid splashing from the
food chute. Ingredients can be
added through the food chute whilst
processing.
If ingredients stick to the sides of the
processor bowl during processing,
turn the speed to the Off (0) position,
switch off at the power outlet, remove
lid and then push the food back onto
the blades using the plastic spatula
to scrape down the sides of the bowl,
then recommence processing.
notE:
Do not over fill the
processor bowl past the ‘MAX’
line for solids and past the
750ml mark for liquids. For
greater quantities of liquids the
blender jug should be used.
When processing is complete,
turn to the Off (0) position. Wait until
the blades have stopped rotating
before removing the lid, blades or
processor bowl.
Assembly And Operation Of
The Blender
Your food processor blender features
2 safety locking devices.
notE:
The blender will not
work unless all of the below
are in place:
1. The blender jug is correctly
positioned and LOCKED onto the
motor base.
2. The processor bowl AND lid are
correctly locked into place (refer to
previous instructions).
notE:
The food processor will
not operate while the blender
jug is assembled to the base. If
processing is required, remove
the blender and fit the blender
drive cover.