USER MANUAL
5
The resultant shock can cause damage to main parts or malfunction,
possibly resulting in injury.
15) Never drive a fastener on hard or thin objects, an edge of the target
surface or a fastener crown already driven.
Otherwise, the fastener fails to be driven in but springs out, thus
inflicting an injury on a worker or those around him or her.
16) Conduct operations in an upright and safe position all the time.
Long-time work in an unstable and wrong position may put excessive
stress on the body, possibly resulting in an injury.
17) When the temperature falls below zero, it is important to note that
you should keep the tool warm in a safe and convenient way.
If you fail to do this, make the tool get warm according to the following
procedure.
1) Control air pressure in the range of 40psi to 70psi.
2) Remove all the fasteners loaded in the tool.
3) Connect the airline to the tool and try mock drive a fastener.
- Keep pressure low enough to operate the tool in a proper way.
- Operate it slowly to let the actuator get warm.
- Piston operation helps bumper and O-ring maintain the original
elasticity.
APPLICATIONS
- Finish and Trim (interior and exterior)
- Decorative Trim
- Cabinets
- Case Backs
- Molding
- Mirror and Picture Frames
- Paneling
