5
Air Nailer F30F http://www.rongpeng.com
3. Compressed air system
Proper functioning of the fastener driving tool requires filtered, dry and lubricated compressed air in adequate
quantities.
If the air pressure in the line system exceeds the maximum allowable of the fastener driving tool, a pressure
reducing valve followed by a downstream safety valve shall additionally be fitted in the supply line to the tool.
NOTE: When compressed air is generated by compressors, the natural moisture in the air condenses and
collects as condensed water in pressure vessels and pipelines. This condensate must be removed by water
separators. These water separators must be checked on a daily basis and if necessary drained, since
corrosion can otherwise develop in the compressed air system and in the fastener driving tool. Which
serves to accelerate wear?
The compressor plant shall be adequately dimensioned in terms of pressure output and performance (volumetric
flow) for the consumption which is to be expected. Line sections which are too small in relation to the length of the
line (pipes and hoses), as well as overloading the compressor, will result in pressure drops.
Permanently laid compressed air pipelines should have an internal diameter of at least 19 mm and a corresponding
large diameter where relatively long pipelines or multiple users are involved.
Compressed air pipelines should be laid so as to form a gradient (highest point in the direction to the
compressor).Easily accessible water separators should be installed at the lowest points.
Junctions for users should be joined to the pipelines from above,
Connecting points for fastener driving tools should be fitted with a compressed air servicing unit(filter/water
separator/oiler)directly at the junction point.
Oilers must be checked on a daily basis and if necessary topped up with the recommended grade of oil (see
TECHNICAL DATA). Where hose lengths of over 10 m are used., the oil supply for the fastener driving tool cannot
be guaranteed, We therefore recommend that 2to 5drops (depending on the loading of the fastener driving tool)of
the recommended oil (see TECHNICAL DATA) should be added via the air inlet of the tool, or an oiler attached
directly to the fastener driving tool. (see fig 5)
4. Preparing the tool for use
4.1 Preparing a tool for first time operation
Please Read and observe these Operating Instruction before using the tool. Basic safety measures should always
be strictly followed to protect against damage to the equipment and personal injury to the user or other people
working in the vicinity of operation.
4.2 Connection to the compressed air system
Ensure that the pressure supplied by the compressed air system does not exceed the maximum allowable pressure
of the fastener driving tool. Set the air pressure initially to the lower value of the recommended allowable pressure
(see
TECHNICAL DATA).
Empty the magazine to prevent a fastener from being ejected at the next stage of work in the event that internal
WARNING
Never free-fire the tool at high pressure.
