R&S ZVH
Putting into Operation
Setting up the R&S ZVH
Quick Start Guide 1309.6900.12 - 06
14
1.3 Setting up the R&S ZVH
The R&S ZVH has been designed for lab operation as well as for service and
maintenance applications on-site.
Depending on the environment, you can adjust the viewing angle of the display and
either lay it out flat or prop it up using the support on the back of the R&S ZVH.
When laid out flat for operation from above, the R&S ZVH is still tilted slightly because
of the grip on its top. This position provides the optimum viewing angle for the display.
To allow easy operation from the front and still be able to read the display, you can
swing out the support on the back of the R&S ZVH.
For use on site or service measurements, it is best to hold the instrument in both
hands. All controls are easy to reach. It is also recommended to use the R&S HA-Z222
carrying bag in order to leave both hands free for work on the device under test (DUT).
You can also use the grip on the top of the R&S ZVH to hang it from cabinet doors, for
example.
Before you turn on the R&S ZVH, you should insert the
lithium ion battery included in the delivery into the battery
compartment. The battery compartment is located on the
bottom right of the R&S ZVH.
(1) Press a finger against the recessed grip and push the
cover down.
(2) Open the cover.
(3) Insert the battery into the compartment with the round
side facing upwards and the handle facing outwards.
(4) Close the cover.
(5) Push the cover up until it clicks fully into place.
You can operate the R&S ZVH with the AC adapter or the battery. Both are included in
the delivery.
