Manufacturer of high quality equipment for powder coating
______________________________________________________
14
1. Check the compressed air connection from filter unit to con-trol
unit. Connect the compressed air supply hose from the
compressed air circuit directly to the filter unit main connec-tion
on the rear side of the equipment (1/4" female BSP)
Note:
The compressed air must be free from oil and water!
2. Connect the black hose for fluidizing air (electrically conduc-
tive) to the output
1.5
on the rear side of the control unit
3. Connect the grounding cable to the control unit with the
grounding screw, and the 5 m long grounding cable with the
clamping clip to the booth or the conveyor. Check ground
connections with Ohm meter and ensure 1 MOhm or less
4. Connect the gun cable plug to the socket
2.3
on the rear side
of the control unit
5. Connect the rinsing air hose to the electrode rinsing air out-
put
1.4
and to the powder gun
6. Insert the injector, connect the powder hose to the injector
and to the powder gun
7. Connect the red hose for conveying air to the corresponding
output
1.2
on the rear side of the control unit and to the injec-
tor
8. Connect the black hose for supplementary air to the corre-
sponding output
1.3
on the rear side of the control unit and
to the injector (this hose is electrically conducting)
9. Connect the mains cable to the
2.1 Power IN
plug and tigh-
ten with provided screw
Note:
If no vibration motor (PROTON II) is connected, the 2.2 Aux output
is to be locked tightly with the provided protection cap!