Step 5 - Fitting the Seals
①
Rebate
1. The Bottom Seal requires a rebate at one end only (Handle side). Fit the Bottom Seal so that the rebated
end is level with the glass at the Handle side of the door and cut it to length so that it butts up to the Hinge
Vertical Extrusion when the Door is closed. Push fully onto the glass.
2. Fit the Bubble Seals to the Hinge Side of the Door Glass, trim as required.
• NOTE: The lower seal should sit as close to the top of the Wall to Dam Joint as possible.
3.
Fit the Top Cap to the Wall Profile and the Branding Badge to the top of the Door Glass.
4.
Fit all the Cover Caps to the screws to the Hinges,Wall Brackets and Bracing.
Branding Badge
Top Cap
③
③
