Step 5 - Fitting the Bracing
②
③
④
⑤
⑥
⑦
⑧
1. Place the Brace Bar over the top of the glass on the Fixed Panel; ensure the Brace Bar is completely level
and in line with the panel.
2. Using a pencil, mark the wall around the barrel that is already fitted to the bracing.
3. Remove the Brace Bar from the panel and loosen the 2 set screws at the end until the locating bush can
be removed (
Take notice as to which way the bush fits
).
4. Take the locating bush and place it in the centre of your pencil mark on the wall, mark the wall through the
hole in the locating bush.
5. Drill the wall using a 6mm masonry drill (not supplied), insert the wall plug and screw fix the locating bush
using the 40mm screw (
Make sure the bush is put on the correct way
).
6. Position the Brace Bar back onto the Fixed Panel and push the barrel over the locating bush and
then tighten the set screws with the Allen key (supplied).
7. Slide the spacers in between the glass and the glass clamp, this will ensure no metal parts touch
the glass. Using a flat screwdriver tighten onto the Fixed Panel.
8. The length of the Brace Bar can be adjusted by loosening the 2 set screws which are on the top of
the barrel and at the end closest to the bar.
