Step 3 - Fitting the Fixed panel
1. Slide the Fixed Panel fully over the Wall Profile, the Fixed Panel must overlap by at least 10mm.
2. Using a Spirit Level ensure the Fixed Panel is completely vertical and it is sitting down on top of the bath
and is also parallel to the outside edge.
3. Drill three holes through the Fixed Panel into the Wall Profile with the 2.5mm drill bit (supplied).
•
Ensure the Fixed panel is sitting fully down on top of the bath and is completely vertical.
4. Place the bases onto the 9mm screws and screw fix the Panel to the Wall Profile. Fit the Cover Caps.
• You will need help to hold the Fixed Panel in position while you drill and fix it.
↓
④
③
10mm
Minimum
Base
9mm Screw
Cover
①
