Step 6 - Sealing
1. Seal both sides of the Wall Profile inside and outside only where it meets the tiles.
2. Fully seal the base of the Fixed Panel to the Bath top from the wall to the end of the Pivot Assembly.
•
IMportant: Do not seal the base on the inside.
3. The Top Cap has grooves and can be shortened by snapping off at these points (adding a small amount of
sealant will help keep the cap in place).
4. Fit the Bottom Seal ensuring that it is fitted with the deflector facing inward towards the bath. Push the seal
up to the aluminium then trim the seal to length as required.
5. Please allow 24 hours for the sealant to fully cure.
6. Ensure the Branding Badge is placed prominently on a none moving aluminium part (where applicable).
①
③
Snap off
here
Grooves
③
Top Cap
Deflector
④
