Rolls-Royce Helicon X3, User Manual

Page: 82 / 140

Maintenance Instructions
Page 8 of 22 Doc. No.: 13S000411
Revision: A
Copyright © 2010 Rolls-Royce plc
Figure 1 Rolls-Royce Marine Boot tool application.
8. Select the position where the new display is placed by pressing on the actual item
on the display. If you are not sure which item to choose, please refer to the Helicon
X3 system drawings.
9. Confirm your choice by pressing OK.
Figure 2 Rolls-Royce Marine Boot tool application.
10. The software and configuration will now be loaded into the display’s memory.
When finished, a confirmation message will appear. Press OK and then Shut down.
Caution: Do not switch off display, unplug power cable or remove the USB pen
drive while software and configuration is loading into memory.
11. When the display is powered off, unplug the USB pen drive and power up the
display again by pressing the on/off switch in front. The display’s original
functionality should now have been restored.
12. Place the USB pen drive back to the storage location so it can be found next time
you need it.