20
RolliBot RolliCool Mini-Split AC User Manual
3. Remove the fi lter and empty the debris into a waste receptacle.
4. Rinse the fi lter in lukewarm water if desired and allow time for it to
dry before replacing it.
5. Mild detergents may also be used.
6.2 – How to Clean the Indoor Unit
• Wipe the exterior clean with a non-abrasive cloth. If needed, the cloth can be damp-
ened with water.
• Do not use harsh chemicals to clean as these may damage the unit.
• Be careful to keep water out of the interior.
6.3 – How to Drain the Unit
In most cases, the Indoor Unit will not require draining. If this is necessary in some special case,
follow the instructions below.
Please make sure your AC unit is completely powered off before performing any
type of maintenance.
1. After turning off the RolliCool, unplug it.
2. If needed, remove the Drainage Pipe’s stopper and
drain the water down away from the unit. Using a bucket is
recommended.
3. To completely dry the inside, use Fan Only Mode for at
least two hours.
4. If the Drainage Pipe needs an extension, materials to do
so can be purchased at most hardware stores.
6.4 – How to Clear Water from Drainage Pipe
If the Drainage Pipe has excessive water that needs to be cleared, follow the instructions below.
Please make sure your AC unit is completely powered off before performing any type of maintenance.
Step 1.
Unplug the unit and remove the Indoor Unit from the wall.
Step 2.
Place the unit on a sturdy surface and remove the Coupler Cover.
Step 3.
Use needle nose pliers to pinch the Drainage Pipe’s metal clasp to release the pipe from
the unit.
Step 4.
Clear the water from the Drainage Pipe.
Step 5.
Connect the Drainage Pipe back to the unit and push the clasp around the pipe where it
is connected to the unit.
Step 6.
Use needle nose pliers to fi x the metal clasp back in place.
Step 7.
Replace the cover, add and tighten the screw, and place the unit back on the wall.
Drainage
