Rollerdor RD55 and RD77 Roller Garage Door User Guide
DELETING REMOTE CONTROL HANDSET’S MEMORY
1
Located the red learn button on the top right hand side of the board next to the digital display
(fig.2.2)
and press and old till the digital display comes up D.E.L then release.
2
Press and release the red learn button again and the D.E.L display should flash.
3
All handsets should now be deleted please test handset to see if this has worked.
BATTERY REPLACEMENT
1
Remove all three screws from back of the handset
2
Turn case over and remove front
3
Carefully remove circuit board to gain access to battery
4
Change battery with new replacement one (CR2032)
5
Carefully replace front cover
6
Turn handset over and screw back in the three screws.
7
Test handset blue light should come on
4
1
Slide the black cover down on the remote control
handset and you will reveal four buttons
(fig.2.1)
2
Press and hold the left button ( ), then press and
hold the right button ( ) if the door moves then the
handset is already programmed in, please repeat
with all other handsets if they are all programmed
please proceed to ‘Direction of rotation Section’, if
not then carry on to step 3.
3
With the handset in hand, located the red learn
button on the top right hand side of the board next
to the digital display
(fig.2.2)
and press and old till
the digital display comes up S.T.U then release.
4
Press and release the top button on the
handset twice.
5
The S.T.U display will flash quickly to indicate
success.
6
Repeat for all handsets.
fig.2.1
fig.2.2
PROGRAMMING REMOTE CONTROL HANDSETS
