Rollerdor RD55 and RD77 Roller Garage Door User Guide
10
fig.8.1
1
Press and hold the “RADIO PROG” button
(fig.8.1)
.
You will hear a beep and the red LED alongside “C1”
will illuminate.
2
Insert screwdriver between the 2 pin terminals on the
board (MR) to bridge between them
(fig.8.1)
.
3
Press and hold the “RADIO PROG” button
(fig.8.1)
.
The panel will beep 10 times and then go into 1
continuous beep. As soon as you hear this, release
“RADIO PROG” button and then remove screwdriver
from terminals and board will stop beeping.
4
Leave for several seconds and the receiver box will
beep twice to confirm end of programming.
To clear memory you will need a small screwdriver.
CLEARING MEMORY OF REMOTE
CONTROL HANDSETS
(SAFETY EDGE)
MR
BATTERY
REPLACEMENT
REMOTE CONTROL FOBS
At the back of the handset where the key hook is located there is a small screw which needs to be removed
before opening the handset to give access to the battery, which is a CR2032 button cell.
SAFETY EDGE SYSTEM
On the base rail unit on the right side (where the writing is) push at the end of the grey cover and slide to the
left. This will give access to the batteries, which are a quantity 2 AA cells.
WIRELESS PUSH BUTTON
Remove the unit from the wall and you will have access to the battery, which is a CR2032 button cell.
WIRELESS KEY PAD
Remove the front of the unit by taking out the 2 screws, you will have access to the batteries, which are
quantity 2 AAA cells.
