Rollei VD-10, Manual, Page: 29 / 44

29
Product Installation
Charging the digitizer battery
To charge the digitizer, connect the supplied USB cable to the
digitizer‘s micro USB port (1) and a USB power adapter with 5V, 2A or
a USB port on your PC/laptop.
For the power supply unit, use an easily accessible socket. The
charging process takes approx. 4 - 6 hours. It may take longer on the
PC/laptop. If the digitizer is switched off, a prompt appears when
charging on the PC/laptop with the options „Charge battery“, or
„Data transfer“. Select the option „Charge battery“ and confirm it
with the OK button (13/24). The digitizer can be used normally during
the charging process. To do this, simply slide the on/off switch (7/20)
to the „On“ position, or press the „On“ button (20) on the remote
control if the on/off switch (7/20) is already in the „ON“ position.
Inserting the batteries in the remote control
Open the battery compartment cover of the remote control by
sliding it down in the direction of the arrow. Always replace both
batteries (type AAA) at the same time. When inserting the batteries,
pay attention to the polarity indicated in the battery compartment.
Close the battery compartment again.