Rollei Bullet 3S, Manual

Page: 6 / 18

Installation
1.The Rollei Bullet 3S 720P can be either handheld or realized non-hand-held use combining with various
non-hand-held accessories. The camera can be installed in where you want; or the camera can be
installed in the water by the waterproof case to photograph scene in the water.
The installation is shown as follows:
(1)Installation and removal of TFT display screen and main body
(2)Installation of waterproof case and main body
Pull out display screen: Please pull out the display screen after pressing Push key.
Note to use waterproof case
★
Handle with care to avoid damaging waterproof case caused by drooping or physical shock.
★
Please clean with clear water as quickly as possible after using and dry out to avoid rusting.
2.Installation of remote control
There is a separate remote control attached to the Rollei Bullet 3S 720P. Please install the remote control
onto the correct position based on the accessories below:
(1)Velcro (2)Clip (3)Binding tape (optional)
Operating Instructions:
Preparations before use:
(1)Start up and check the power of the Rollei Bullet 3S 720P .
Turn the power switch to “ON” to switch the camera on. After the red indicator is bright constantly, the
corresponding icons on LCD segment screen will be lightened to enter normal preview state.
At this time, the following items will be shown on the LCD screen:
A.Record mode: The current record mode can be viewed on the top left corner of LCD segment screen,
“ ” indicates the video recording mode and “ ” indicates the voice recording mode;
B.Photo shooting prompt: The shooting icon “ ” can be viewed on the LCD segment screen. The icon
will twinkle once when shooting one photo;
C.Power icon: The power icon “ ” can be viewed on the top right corner of LCD segment screen. The
icon will be bright constantly after the system coming into play; and the disappearance of the icon means
the Rollei Bullet 3S 720P is shut down or enters the standby state;
TFT display
screen Main body
Main body Waterproof
case
Install main body into
the waterproof case
Install TFT
display screen
onto the main body
-4-
Note:The Remote control is not waterproof.
EN
DE
FR
ES
EL
SV
NL
PL
RU
HU
PT
FI
NO
IT
DA
TR