© 2015 Rollease Acmeda
© 2015 Rollease Acmeda
2. INSTALLATION
2.1 WARNING: Important safety instructions to be read before installation.
Incorrect installation can lead to serious injury and will void manufacturer’s liability and warranty.
•
Installation and programming to be performed by a suitably qualified installer.
•
For use within tubular blinds & awnings.
•
Ensure correct crown and drive adaptors are used for the intended system.
•
Use only Rollease Acmeda hardware.
•
Before installation, remove any unnecessary cords and disable any equipment not needed for powered operation.
•
Ensure torque and operating time is compatible with end application.
•
Do not expose the motor to water or install in humid or damp environments.
•
Tube and the drive adaptor should be evenly fixed with 4 pieces of 4x10 countersunk self-tapping screws. Ensure
screw tip does not penetrate through the internal surface of the drive.
•
Motor is to be installed in horizontal application only.
•
Do not drill into motor body.
•
For awning installation, a horizontal distance of at least 0,4m is to be maintained between the fully unrolled
driven part and any obstacle.
•
Ensure at least one control point is located within direct sight of unit but away from any moving parts.
•
The routing of cable through walls shall be protected by isolating bushes or grommets.
•
Ensure power cable and aerial is clear and protected from moving parts.
•
Power supply cables are not be exposed to sunlight and must be protected by U.V resistant conduit.
•
Ensure power is isolated prior to connecting or disconnecting inline connector.
•
If cable or inline connector is damaged do not use.
Page. 3 of 12
