Roland TRI-Capture, Owner'S Manual

Page: 13 / 52

13
Panel Descriptions
16. INPUT 1 (MIC) jack
This is an analog audio input jack. Rated input level: -60– -30 dBu
This jack can provide 48 V phantom power, allowing you to connect a phantom-powered condenser
microphone. In this case, set the [PHANTOM] button to “48V.”
* This instrument is equipped with balanced (XLR, TRS) type
jacks. Wiring diagrams for these jacks are shown in the
illustration.Make connections after first checking the wiring
diagrams of other equipment you intend to connect.
Bottom Panel
*
When turning the unit upside-down, get a bunch of newspapers or magazines, and place them
under the four corners or at both ends to prevent damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or controls get damaged.
17 18
17. [SAMPLE RATE] switch
Sets the sampling rate for the audio signal to be recorded or played.
When you switch the sampling rate, disconnect the USB cable that connects the TRI-CAPTURE and
computer, then reconnect it.
18.
[MODE] switch
Selects recording mode or playback mode when the [SAMPLE RATE] switch is set to “96k.”
When the [SAMPLE RATE] switch is set to “96k,” the TRI-CAPTURE cannot record and play audio data
simultaneously. For recording, set the [MODE] switch to “REC,” and for playback, set the [MODE]
switch to “PLAY.”
1: GND 2: HOT
3: COLD