Settings for the Entire TD (SYSTEM)
45
Connecting the VH-11 and making
settings on the TD
Connections
TRIGGER OUT
jack
Connect the HH cable
CONTROL OUT jack
Connect the HHC cable
Motion sensor unit
Clutch screw
Settings
1.
Make sure that the VH-11 is correctly connected
to the TD .
2.
Set up the hi-hat, take your foot off the pedal,
and power-on the TD .
* It will be impossible to make the adjustment correctly
if the hi-hat is touching the motion sensor when you
turn on the power.
3.
Loosen the clutch screw, and allow the hi-hat to
rest naturally on top of the motion sensor unit .
4.
Proceed up through step 5 of the basic
procedure (p . 34) to access the PAD SETTINGS
screen .
5.
Press the [F1] (TYPE) button .
6.
Use the cursor buttons ( / ) to select “HH .”
7.
Use the value dial to select “VH-11 .”
8.
Press the [F3] (ADVNCD) button, and then press
the [F3] (HIHAT) button .
The following screen will appear.
9.
While you watch the meter that’s displayed in
the left side of the screen, turn the VH-11’s VH
offset adjustment screw to adjust it .
Adjust the screw so that the appears in the meter.
VH Offset
Adjustment Screw
CLOSE
OPEN
VH Offset Adjustment Points
If the closed hi-hat sound is difficult to attain,
rotate the VH offset adjustment screw towards
“CLOSE.”
If the open hi-hat sound is difficult to attain,
rotate the screw towards “OPEN.”
NOTE
If the sound cuts off when you strike the hi-hat
forcefully, rotate the VH Offset adjustment
screw towards “OPEN.”
10.
Adjust other parameters as needed .
NOTE
If you don’t set up the VH-11 correctly, it may not
operate correctly.
