3-5 Loading Material (Using the Center Vise)
Chapter 3 Performing Printing
34
Loading Material Using the Center Vise
Procedure
➊
Attach a head cap.
Fit the head cap into place on the tip of the
head. The head cap is attached correctly when
its tab clicks into place in the hole in the head.
☞
P. 27, "Head Caps"
➋
Loosen the knob.
➌
Load the material in the center vise.
Adjust the retaining screw to clamp the ma-
terial in place in the vise. Tighten the retain-
ing screw enough to keep the material from
easily coming loose. Be careful not to over-
tighten, because doing so may damage the
material.
☞
P. 33, "Using the Center Vice"
Knob
Head cap
Head cap
Retaining
screw
Center in the
vertical direc-
tion
Tighten
Loosen
Head
Head
Summary of Contents for Metaza MPX-80
