149
Chapter 8 Various Settings
Chapter 8
❍
Functions that can be assigned (Pedals
Only)
* The effect may not be applied correctly when you press a pedal
if “Pedal EX1–4” is assigned to more than one pedal.
→
Using the “Bend Up” or “Bend Down” function during a
split performance (p. 28) changes the pitch of sounds in the
right-hand side of the keyboard. Additionally, the range in
which the pitch can change when the Bender effect is used is
called the “bend range”; refer to “Changing the Bend Range
(Pedal Setting)” (p. 149).
■
Changing the Bend Range
(Pedal Setting)
The effect of smoothly raising or lowering the pitch of a
played note is called the “bender effect.”
With the KR-7/5, you can assign the bender function to a
pedal, then apply the bender effect by depressing and
releasing the pedal.
You can also make a setting that determines how much the
pitch of the note changes when you apply the bender. The
maximum range of change in pitch is called the “bend
range.”
At Step 3 “Procedure” (p. 145), touch <Pedal Setting>.
fig.d-pedalset.eps_50
Touch <Bend Range>
to adjust the bend range
setting.
You can set this to any value within a range of 1 to 12 (in
half-tone steps, up to one octave).
Function
Explanation
Replay
Pressing the pedal during playback of a song
stops the playback. When the pedal is
released, playback resumes from the begin-
ning of the measure that was playing when
the pedal was pressed. When the pedal is
pressed in rapid succession, the playback
will resume backs up the same number of
measures as the number of times the pedal is
pressed.
Upper
Soft
The pedal functions as a soft pedal (p. 20).
Upper
Sostenuto
The pedal functions as a sostenuto pedal
(p. 20).
Lower
Damper
Applies a damper pedal effect to the sounds
in the left-hand side of the keyboard.
Bend Up
This raises the pitch of notes you play on the
keyboard.
Bend
Down
This lowers the pitch of notes you play on the
keyboard.
Pedal EX1
When the pedal is pressed during a layer per-
formance, the Tone volume changes between
two levels, depending on how firmly the
pedal is pressed.
Pressing the pedal with “Pedal EX1” selected
increases the layer Tone volume. The layer
Tone is played at a fixed volume, regardless
of how forcefully the keys are played.
Pedal EX2
Pressing the pedal with “Pedal EX2” selected
increases the layer Tone volume.
Pedal EX3
Pressing the pedal with “Pedal EX3” selected
increases the layer Tone volume, while the
volume of the left-hand Tone is decreased.
The layer Tone is played at a fixed volume,
regardless of how forcefully the keys are
played.
Pedal EX4
Pressing the pedal with “Pedal EX4” selected
increases the layer Tone volume, while the
volume of the right-hand Tone is decreased.
KR-7_5_e.book 149 ページ ２００４年７月７日 水曜日 午前１０時３分
