Manual Version 3.21
Page. 13 of 73
TIP
: C1 and C2 can now be assigned to any tone parameter (Tone A, B or both) by pressing the TONE button
: or you can use the method shown below to edit the patch.
When C1 or C2 is selected, any of the following four functions can be assigned:
“
-
” in the Display actually shows 1 or 2 depending which of
or
is pressed
**
shows the value set in the Patch Memory
Display
Description
Adjusts the volume balance of the Upper
and Lower.
Raising the knob increases the Upper
volume, and lowering the knob increases
the Lower volume.
Adjusts the Portamento time.
Raising the knob
increases the
Portamento time.
Adjusts the volume within the range of the
maximum volume set with the Master
Volume. Raising the knob raises the
volume, reaching the maximum volume. At
the same time, the MIDI volume of the
Upper and the Lower change.
Controls the MIDI messages of the Upper
or Lower section
Refer to the “MIDI” section on
page 41
.
•
With the new firmware, once C1 and C2 are assigned two different Factors, they will be controllable by C1 and
C2 sliders respectively, in real time.
*When PEDAL SWITCH is selected, any of the following four functions can be assigned.
Display
Description
Pressing the pedal changes the Bank and
the Number of the Patch Memory.
A1
→
A2 ........ AB
→
B1
→
B2 ........
Turns the Portamento ON or OFF.
Turns the Chase Play function (p. xx)
ON or OFF.
Turns the Hold Effect ON or OFF for the
Upper and/or the Lower section.
C
-
ASSIGn 11 u/l bal
**
C
-
ASSIGn 15 porta time
**
C
-
ASSIGn 18 total vol
**
C
-
ASSIGn 65 up midivol
**
C
-
ASSIGn 66 lo midivol
P5 ASSIGn patch shift
P5 ASSIGn portamento
**
P5 ASSIGn chase play
**
P5 ASSIGn upper hold
**
P5 ASSIGn lower hold
**
