Manual Version 3.21
Page. 11 of 73
4.2 CONTROL KNOB FUNCTIONS
The following controls can be operated whilst you are playing the JX-10.
a. Control Assign sliders
Each of these two sliders can be used for controlling the performance control function you select with the Control
Assign button.
(See page 12 “Control Assign”)
b. Bender lever - Bend Range switch
This Bender lever can be used during live performance for creating a guitar “choke-bend” effect. The left and right
extremes of movement create the same amount of pitch bend effect up or down. The maximum effect of the bender
can be selected with the Bend Range switch: major 2
nd
, minor 3
rd
, major 3
rd
, perfect 5th, perfect octave higher or
lower.
Pressing the Bender lever forward will create a vibrato effect. When the tone you are using already has vibrato
assigned to it, the effect will be deepened (unless it is already set to max).
c. Aftertouch Fine Adjust slider
The Aftertouch effect is the ability to change the sound by the amount of downward pressure applied to the key (or
keys). When a note or chord is played, pressing harder generates an Aftertouch signal proportional to how “hard”
you press. The JX-10’s Aftertouch effect works on the Vibrato, Brilliance and/or Volume.
Vibrato:
The depth of the vibrato effect is deepened.
Brilliance:
The tone will become brighter.
Volume:
The volume of the sound will increase.
The On/Off setting or value of each Aftertouch effect
can be written to each Patch Memory independently
but the Aftertouch Fine Adjust knob allows even
more delicate adjustment of the effect. When this
knob is set to the center position, the same effect as
set in the Patch Memory can be obtained, and no
effect is obtained at the lowest position [-].
* Different On/Off settings and values of the
Aftertouch and Bender are written to each of the 64
Patch Memories. Therefore, the actual effect you
hear can differ depending on how these are set up in
each of the Patch Memories: No effect may be
obtained in some particular settings.
d. Voice Memory switch
This switch selects which memory mode; the JX-10’s Internal memory or the Cartridge memory is to be used.
CART
INT
Patch
Memory
You can recall a Patch Memory
from the Cartridge to the JX-10
You can recall an Internal Patch Memory
to the JX-10
Tone
Tone Numbers 1 to 50
= Tones in the Cartridge
Tone Number 1 to 50
= Tones in the JX-10
Tone Number 51 to 100 = Tones in the JX-10 ROM only
Even after you have changed Memory modes with the Voice Memory switch, the new selected position does not
affect the memory until you select a NEW Patch Memory.
When you select a new Patch Memory, “I” (Internal) or “C” (Cartridge) is shown at the left end of the Display,
(
Area A
) depending on which position has been selected with the Voice Memory switch.
