9
3 Part Names
The table grips the workpiece
to be cut.
(Described on the following
page.)
Tool carriage
Control Panel
Table
Front
Rear
Power switch
Depth regulator nose
This secures the depth regulator
nose or tool adapter in place.
Tool mounting screw
This is used to attach the
character cutter for engraving
and to adjust the amount of
blade extension.
Dust collector hose port
This is where the dust collector
is attached to take up cuttings
while engraving is in progress.
Removing the Safe-transport Retainers
Retainers are attached at the locations shown in the
figure to ensure safety when transporting this
product.
Use the hexagonal wrench included with the unit to
remove the retainers before use. (Once removed, the
retainers should be stored in a safe place because they
are needed again when repacking the product.)
A serial (RS-232C) cable is
connected here.
Serial connector
Parallel connector
A parallel (printer) cable is
connected here.
The power cord included with the
machine connected here.
Power connector
Safe-transport
Retainer
Summary of Contents for EGX-30
Page 31: ......