25
10 If There's a Problem...
If operation of the EGX-30 becomes abnormal, immediately switch off the power to the unit.
Make sure the power cord is plugged in securely.
No Power
Is the power switch set to ON?
Make sure the power is turned on.
Is the power cord plugged in correctly?
Output Results Are Shifted from the Desired Location
Has the origin point been set correctly?
If the material has been changed, is it positioned differently than before?
The Material Is Not Cut Correctly
Are there any cuttings scraps adhering to the tip of the cutter?
Is the right combination of tool and material being used?
Has the correct cutting mode been selected?
Is the tool securely tightened so that it will not move or come loose?
Is the material secured in place so that it will not move or come loose?
No Operation When Commands Are Sent from the
Computer
Are the computer and the EGX-30 connected correctly?
Is the power switch set to ON?
Are the computer (software) settings correct?
Is the application software functioning correctly?
Is the cutter broken?
Make sure the cable to the computer is securely connected.
Make sure the power is turned on.
Check the state of the computer and software.
Refer to the documentation for the computer and software application to make the correct settings.
Replace the cutter with a new one.
Remove the cutter and wipe the tip with a soft cloth.
Refer to
"About Tools and Materials"
and choose the appropriate tool for the material to be cut.
Check the
SELECT
setting on the operation panel.
Refer to
"Loading the Material"
and use the appropriate method for the material type to secure the material in place.
Refer to
"Installing a Tool"
to install the tool securely.
Refer to
"Setting the Origin Point"
to set the material's origin point correctly.
Check the position where the material is loaded.
Summary of Contents for EGX-30
Page 31: ......
