Roland EGX-30, User Manual

Page: 17 / 32

15
SET ORIGIN VIE W TEST
Interface Setup
1
2
4
3
Switch on the EGX-30 power switch.
(The
PAUSE
LED flashes at this time.)
Press the PAUSE/VIEW key.
The tool carriage moves to the left rear.
Communication parameters for a serial connection
The tool carriage stops when it reaches the VIEW
position (inner right-hand side).
To ensure safety, operation of the EGX-30 is paused when the power is switched on.
Press the
PAUSE/VIEW
key to end the paused state.
Powerup
EGX-30 automatically detects the type of interface (parallel or serial) from the first batch of data sent from the computer
after the power is switched on.
When using a serial connection for the interface, however, the communication parameters on the computer should be set
as follows.
The communication parameters for the EGX-30 are locked in and cannot be changed.
The EGX-30 is now ready to receive data.
Stop bit 1bit
Data bit 8bit
Parity None
Baud rate 9600bps
Handshake Hardware