8
5. Setting the Connection Parameters
Connection with a parallel cable is called a "parallel connection," and connection with a serial cable is called a "serial connection."
Make the appropriate settings on both the computer and the PNC-300 to configure the equipment for the type of connection that has
been made. Normally, the setting on the PNC-300 should be made to match the setting on the computer. The steps below describe how
to set connection parameters on the PNC-300. To make the settings on the computer, refer to the manual for the computer or the
software in use.
Press the
[MENU]
key to make the following screen
appear on the display.
1
Press the
[ ]
key to move the blinking cursor (" ") to
"
OTHERS
," and then press the
[ENTER]
key.
2
Press the
[MENU]
key to make the following screen
appear on the display.
3
Press the
[ ]
key to move the blinking cursor (" ") to
"
I/O
," then use the
[ ]
or
[ ]
keys to select "
AUTO
."
4
Press the
[MENU]
key once.
6
Press the
[ENTER]
key.
5
For serial connection
only
Make sure
that "< >" appears.
Make the settings for baud rate and handshake.
8
Make the settings for stop bit, data bits, and parity
check, then press the
[MENU]
key once.
7
For serial connection
only
For serial connection
only
* "
REPEAT
" is displayed only
when the buffer size has been
expanded.
