12. For each cross bar, tighten the two end supports
alternately (LH and RH), turning the tensioning
bolt just a few turns until tight while holding the
door frame straps firmly against the vehicle.
Fig. A
The end support assembly is tightened when
the wrench markings align at the 4NM marks.
Fig. B
Push and tug on the now installed cross bar
assemblies to check for tightness in all 4
mounting positions. If any looseness is detected,
review the installation steps and redo until
completely firm.
Fig. C
Store your ROLA torque wrench in the vehicle’s
glove box or some other safe storage place.
CAUTION: Check the tensioning bolt torque
reading periodically on long trips or if the
cross bars remain on the car for long periods
of time.
13. Close and lock the end support covers by turning
the quarter turn plugs to the locked icon position.
INSTALLATION INSTRUCTIONS
PAGE 11
No Torque
4Nm Torque
Torque Markings
!
Fig. A
Fig. C
Fig. B
