INSTALLATION INSTRUCTIONS
PAGE 8
5. Slide the DFE end supports into the rails and up to the positioning slider end tabs at their preset
positions (X and Y).
6. Lock the DFE end supports into position by closing the cam levers.
Fig. B
7. Slide the outer under-cover strips into the bar, mark with a pencil for length, remove and cut
.
Fig. C
Tip: Cut approx. 1/8” or 2mm longer than needed to avoid gaps.
Slide under-covers into place and install the end caps.
Tip:
place bar upside down for
easier handling of parts
End Tab
Fig. B
Note:
Careful not to pinch
fingers or hand!
Note:
Insure that the end support has not
moved after closing cam lever.
!
Fig. A
Fig. C
Cam Lever
