PAGE 9
59307_59308_59310_IN_Rev A • Questions? (800) 234-6992 • RolaProducts.com
ENGLISH
ASSEMBLY INSTRUCTIONS
59307 1-1/4 in. / 59308 2 in. Base Units
LOADING BIKES (continued)
Securing by the frame:
1. Be sure rotating arm assembly (G) is on the rear cradle tube side (E).
See page 6 figure 4a for reference. Place rotating arm assembly (G) in
the “unlocked” position. Depress grip trigger and move grip up shaft to
maximum height.
FIG 1.
Note
: It may be easier to remove grip completely, depending on bike
style.
2. Lift bike onto carrier and place front wheel onto front wheel tube
cradle (D). While supporting bike with one hand, rotate arm assembly
(G) upward to vertical position
FIG 2
.
Note
: Arm assembly (G) must be
locked in the vertical position to properly secure frame. Reinstall grip
(H) (if removed). Center “V” shape in hook frame and pull downward
on grip to secure
FIG 3
.*
3. If you are unsure that you pulled down hard enough on grip, push
down on the grip lever. This will move the grip downward one more
detent and lock the grip.
FIG 4
.
4. Secure rear tire by aligning rear cradle strap (F) with rear axle of bike.
Place strap through spokes while rotating tire as needed, then slide
into buckle. Pull downward on strap.
FIG 5
.
* NOTE
: For frame mounting, hook must be as close to top tube/seat tube
intersection as possible
FIG 3
.
NOTE:
If your strap is too short, or if you have a fat tire bike, replace
with longer strap (P) (supplied). Refer to page 12 for strap replacement
instructions.
2
3
1
Grip
Maximum height
Rotating arm
assembly
G
Grip lever
Grip triger
H
4
Grip lever
Grip
H
5
Rear cradle
strap
F
Front wheel tube
with cradle
D
Rear cradle tube
with strap
E
Grip triger
